A practical reference on Sublimation: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-02-12. Anything still debated is marked as such rather than presented as settled.
Lyophilization is a dehydration process that removes water from a frozen material by sublimation under low pressure. The material is first frozen so that water becomes ice; then the surrounding pressure is lowered below the vapor pressure of ice. Heat is applied gently so ice changes directly to vapor without passing through a bulk liquid phase. The vapor is collected on a cold condenser, leaving a dry porous matrix. This process differs from simple evaporation because the material remains frozen during the main drying stage.
The process usually has three stages: freezing, primary drying, and secondary drying. Freezing sets the ice crystal structure and can determine pore size in the final cake. Primary drying removes free ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, although some water may remain as part of the solid. Cycle parameters depend on formulation, fill volume, vial type, and equipment performance.
Lyophilized solids are often hygroscopic, so handling occurs in controlled low-humidity areas or glove boxes when the material is exposed. Vials remain sealed with elastomeric stoppers and aluminum crimps until use, because airborne moisture can raise residual water and shorten shelf life. The porous cake is fragile and may crack, shrink, or powder during transport. Personnel typically avoid repeated warming and cooling of sealed units, which can draw moisture through closures. These practices aim to preserve the low water content achieved during drying.
Storage conditions depend on the formulation and the intended shelf life. Many pharmaceutical and biological freeze-dried products are kept at 2–8 °C, while some stable foods and reagents tolerate room temperature. Others require −20 °C or colder to slow chemical degradation or aggregation. Protection from light and oxygen is common because oxidation can continue in the dry state. Stability studies usually monitor potency, appearance, moisture, and reconstitution time over months or years. Predictions from accelerated studies are useful but may not fully capture real-time changes.
| Property | Value | Notes |
|---|---|---|
| Common synonyms | Freeze-drying, lyophilisation | Lyophilisation is the British spelling; the process is not simple evaporation. |
| Primary drying pressure | 0.05–0.3 mbar | Pressure must remain below the vapor pressure of ice at the product temperature. |
| Sublimation temperature | Below 0 °C | Ice changes directly to vapor while the product remains frozen. |
| Typical shelf temperature | −40 to −10 °C | Exact setting depends on formulation critical temperature and equipment. |
| Cycle duration | 12–72 hours | Time varies with fill volume, formulation, and dryer performance. |
Lyophilization removes water by freezing a material and then lowering pressure so ice changes directly to vapor. The process relies on sublimation, the phase transition from solid to gas without an intermediate liquid state. Because the material remains frozen during primary drying, the structure often stays porous. This porous matrix can rehydrate quickly when water is added back. The low pressure also allows vapor to leave the solid matrix without boiling.
A typical cycle begins with freezing, which fixes the material into a solid and determines ice crystal size. Primary drying then raises heat under vacuum so ice sublimes, often near or below the collapse temperature of the formulation. Secondary drying removes bound water that remains after ice is gone, usually by gently warming the product. Each stage balances heat input against pressure to avoid melting or structural damage. Temperature probes and pressure sensors guide the transition between stages.
Lyophilized products are typically hygroscopic and require protection from moisture during storage. Manufacturers seal them in glass vials, often under vacuum or an inert gas such as nitrogen. The container closure system, including the stopper and crimp seal, must prevent water vapor ingress. Storage temperature varies from controlled room temperature to refrigerated or frozen conditions, depending on the formulation. Humidity-controlled environments are essential because even brief exposure to ambient air can degrade the product.
Stability of a lyophilized product depends on its glass transition temperature, the temperature at which the amorphous cake transitions from a glassy to a rubbery state. Storage below this temperature minimizes molecular mobility and slows chemical degradation. If the storage temperature exceeds the glass transition temperature, the cake may collapse, shrink, or become sticky. Accelerated stability studies at elevated temperatures and humidity help predict shelf life, but they do not always reflect real-time behavior. Residual moisture content also plays a critical role in long-term stability.
== Education == Synovec was born in 1959 to Eugene "Gene" Synovec and Joan Synovec. Synovec graduated with a BS in chemistry from Bethel College in 1981. He obtained his PhD from Iowa State in 1986 working under Edward Yeung where he developed detection and data analysis methods for liquid chromatography. He started at the University of Washington in 1986.
== History == Porous silicon was discovered by accident in 1956 by Arthur Uhlir Jr. and Ingeborg Uhlir at the Bell Labs in the U.S. At the time, the Uhlirs were in the process of developing a technique for polishing and shaping the surfaces of silicon and germanium. However, it was found that under several conditions a crude product in the form of thick black, red or brown film were formed on the surface of the material. At the time, the findings were not taken further and were only mentioned in Bell Lab's technical notes. In the early 1980s, researchers at the Royal Signals and Radar Establishment (RSRE) in Malvern, England, carried out the first systematic study of the formation and microstructure of porous silicon. In 1985, Beale, Benjamin, Uren, Chew and Cullis published two key papers establishing that porous silicon was not a deposited stain film, as previously assumed, but was formed by electrochemical etching of pores with aspect ratios exceeding 1000:1. Using cross-sectional transmission electron microscopy, they identified two distinct types of porous silicon microstructure, dependent on the dopant concentration: in heavily doped (degenerate) silicon, current transport through the Schottky barrier at the silicon–electrolyte interface proceeds by quantum mechanical tunnelling, while in lightly doped (non-degenerate) silicon it occurs via thermionic emission.
Both types of diabetes, if untreated, result in too much glucose remaining in the blood (hyperglycemia) and many of the same complications. Also, too much insulin and/or exercise without enough corresponding food intake in diabetics can result in low blood sugar (hypoglycemia).
Sources: en.wikipedia.org
== Tissue distribution and secretion == Human and mouse PGLYRP2 is constitutively expressed in the adult and fetal liver, from where it is secreted into the blood. PGLYRP2 (NAMLAA) is present in human plasma at 100 to 200 μg/mL and at lower concentrations in saliva, milk, cerebrospinal fluid, and synovial fluid. PGLYRP2 is also expressed to a much lower level in the colon, lymph nodes, spleen, thymus, heart, and polymorphonuclear leukocyte granules. PGLYRP2 is differentially expressed in the developing brain and this expression is influenced by the intestinal microbiome. Bacteria and cytokines induce low level of PGLYRP2 expression in the skin and gastrointestinal and oral epithelial cells, and also in intestinal intraepithelial T lymphocytes, dendritic cells, NK (natural killer) cells, and inflammatory macrophages. Some mammals, e.g. pigs, express multiple splice forms of PGLYRP2 with differential expression. Bacteria and cytokines induce expression of PGLYRP2 in epithelial cells through the p38 mitogen activated protein kinase (MAPK) and IRAK1 (interleukin-1 receptor-associated kinase 1) signaling pathways. Constitutive and induced expression of PGLYRP2 is controlled by different transcription factors whose binding sequences are located in different regions of the PGLYRP2 promoter. Constitutive expression of PGLYRP2 in hepatocytes is regulated by transcription factors c-Jun and ATF2 (activating transcription factor 2) through sequences in the proximal region of the promoter.
electron pair Two electrons which occupy the same molecular orbital but have opposite spins. Electron pairs form chemical bonds or occur as lone pairs of valence electrons; it is also possible for electrons to occur individually as unpaired electrons.
=== July === 1 July SpudCells, a type of artificial cell, are publicly announced. A study published in Nature reports that GPNMB-targeted CAR-T cells can target both glioblastoma cells and tumour-associated macrophages, eliminating detectable tumours and producing long-term disease control in preclinical models. Astronomers report the discovery of Gaia23bra b, the first gravitationally bound exoplanet detected by the Transiting Exoplanet Survey Satellite using gravitational microlensing. The planet is a super-Jupiter orbiting a K dwarf about 40,000 light-years from Earth. 6 July – A study presented at the Federation of European Neuroscience Societies Forum finds that multilingualism is associated with a younger estimated brain age, with people speaking four languages showing brain-connectivity patterns corresponding to about 13 years younger than monolingual people. 13 July – Astronomers announce the detection of erythrulose molecules inside a cloud of gas and dust near the centre of the Milky Way, marking the first evidence of sugar in interstellar space. 16 July – Astronomers report the first observationally confirmed atmosphere around a rocky exoplanet within its star's habitable zone, after detecting helium escaping from the upper atmosphere of LHS 1140 b, a super-Earth approximately 49 light-years from Earth. 29 July – Researchers report a previously unrecognised pathological structure in Alzheimer's disease, termed a "mitochondrial plaque": an accumulation of damaged mitochondria within neuronal processes, associated with impaired mitophagy and lysosomal function.
Sources: en.wikipedia.org
==== Fraud conviction and imprisonment ==== The PTL Club's fundraising activities between 1984 and 1987 were reported by The Charlotte Observer, eventually leading to criminal charges against Bakker. Bakker and his PTL associates sold $1,000 "lifetime memberships", entitling buyers to an annual three-night stay at a luxury hotel at Heritage USA during that period. According to the prosecution at Bakker's fraud trial, tens of thousands of memberships were sold but only one 500-room hotel was ever finished. Bakker sold "exclusive partnerships" which exceeded capacity, raising more than twice the money needed to build the hotel. Much of the money paid Heritage USA's operating expenses, and Bakker kept $3.4 million. After a 16-month federal grand jury probe, Bakker was indicted in 1988 on eight counts of mail fraud, 15 counts of wire fraud and one count of conspiracy. In 1989, after a five-week trial which began on August 28 in Charlotte, North Carolina, a jury found him guilty on all 24 counts. Judge Robert Daniel Potter sentenced Bakker to 45 years in federal prison and imposed a $500,000 fine. At the Federal Medical Center, Rochester in Rochester, Minnesota, he shared a cell with activist Lyndon LaRouche and skydiver Roger Nelson. The United States Court of Appeals for the Fourth Circuit upheld Bakker's conviction on the fraud and conspiracy charges, voided Bakker's 45-year sentence and $500,000 fine and ordered a new sentencing hearing in February 1991.
One method of feeding libraries into the microfluidic device uses single cell encapsulation, in which droplets contain a maximum of one cell each. This avoids confounding results that could be generated by having multiple cells, and consequently multiple genotypes, in a single droplet, while maximizing the efficiency of resource consumption. This method enables the detection of secreted proteins and proteins on the cell membrane. The addition of a cell lysate to the droplets, which breaks down the cellular membrane such that the intracellular species are freely available within the droplet, expands the capabilities of the single cell encapsulation method to analyze intracellular proteins. The library can also be made entirely in vitro (i.e., not in its biological/cellular context) such that the content of the droplet is exclusively a mutated DNA strand. The in vitro system requires PCR and the use of in vitro transcription and translation (IVTT) systems to generate the desired protein in the droplet for analysis. Sorting of droplets for directed evolution is primarily done by fluorescence detection (e.g., fluorescence-activated droplet sorting (FADS)), however recent developments in a absorbance-based sorting methods, known as absorbance-activated droplet sorting (AADS), have expanded the diversity of substrates that can undergo directed evolution through a droplet-based microfluidic device. Recently, sorting capability has even expanded to the detection of NADPH levels and has been used to create higher activity NADP-dependent oxidoreductases.
that GABAA receptors containing the δ-subunit are sensitive to ethanol modulation, depending on subunit combinations receptors could be more or less sensitive to ethanol. It has been shown that GABAA receptors that contain both δ and β3-subunits display increased sensitivity to ethanol. One such receptor that exhibits ethanol insensitivity is α3-β6-δ GABAA. It has also been shown that subunit combination is not the only thing that contributes to ethanol sensitivity. Location of GABAA receptors within the synapse may also contribute to ethanol sensitivity. Ro15-4513, a close analogue of the benzodiazepine antagonist flumazenil (Ro15-1788), has been found to bind to the same site as ethanol and to competitively displace it in a saturable manner. In addition, Ro15-4513 blocked the enhancement of δ subunit-containing GABAA receptor currents by ethanol in vitro. In accordance, the drug has been found to reverse many of the behavioral effects of low-to-moderate doses of ethanol in rodents, including its effects on anxiety, memory, motor behavior, and self-administration. Taken together, these findings suggest a binding site for ethanol on subpopulations of the GABAA receptor with specific subunit compositions via which it interacts with and potentiates the receptor.
Sources: en.wikipedia.org
The main change is sublimation, in which ice becomes water vapor without melting into liquid water. This occurs when the chamber pressure is held below the vapor pressure of ice while mild heat is supplied. The result is a dry, porous solid that retains much of its original shape.
Freezing determines ice crystal size, solute distribution, and the pore network left after drying. A slow or fast freezing rate can produce different cake structures and affect reconstitution. It also sets whether the formulation follows an amorphous or crystalline drying path.
It removes most free water during primary drying and part of the bound water during secondary drying. A small residual moisture content often remains and is specified for each product. Complete removal is generally neither practical nor desirable for stability.
Karl Fischer titration is widely used because it is specific for water and works at low levels. Loss on drying is simpler but less specific, since volatile solvents or decomposition products can also be lost.