Everything below concerns Collapse temperature. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2025-11-13. Where a claim depends on a specific study, the study is described rather than over-claimed.
Freezing determines ice crystal structure and pore size, which affect drying speed and product uniformity. Rapid freezing creates small crystals, while slow freezing creates larger crystals and often faster sublimation. During primary drying, chamber pressure is held below the vapor pressure of ice, and shelf temperature supplies heat for sublimation. The ice front recedes, leaving a porous matrix. Thermal limits such as collapse and eutectic temperatures set safe boundaries for formulation. These limits vary with solute composition and concentration.
Secondary drying removes bound water that remains after ice sublimation. Shelf temperature is raised gradually while pressure remains low, reducing water content to a target range. Over-drying can cause brittleness or electrostatic issues, while under-drying affects stability. The endpoint is often judged by pressure rise tests, temperature measurements, or water content analysis. Scale-up depends on matching heat and mass transfer across equipment sizes. Small changes in shelf temperature or pressure can alter cycle length substantially.
Analytical methods for lyophilized solids must account for the low moisture content and the fragile cake. Karl Fischer titration is widely used for water content, while near-infrared spectroscopy can measure moisture non-destructively in sealed containers. X-ray diffraction and modulated differential scanning calorimetry help identify crystalline or amorphous phases. Residual solvent analysis may be needed if organic solvents were used during formulation. The combination of these methods supports batch release and long-term stability assessment.
Lyophilized products are typically stored as sealed solids in vials or syringes. Moisture ingress is a major concern because many dried cakes are hygroscopic and can lose stability when exposed to humid air. Storage temperature depends on the formulation; some products are kept refrigerated, while others are stable at room temperature. Container closure integrity and headspace moisture are often monitored. Light protection may also be required for some photosensitive materials.
Quality control for lyophilized materials includes visual inspection, residual moisture measurement, and reconstitution testing. Cake appearance can reveal process problems such as collapse, shrinkage, or meltback, although appearance alone does not prove potency. Residual moisture is commonly measured by Karl Fischer titration or by loss on drying. Reconstitution time is checked because a slow or incomplete dissolve can indicate a change in pore structure. Stability studies track these attributes over time under defined temperature and humidity conditions.
| Property | Value | Notes |
|---|---|---|
| Process name | Lyophilization or freeze-drying | Both terms appear in technical standards and literature. |
| Phase transition | Sublimation | Solid ice becomes vapor without a liquid step. |
| Typical chamber pressure | 0.05-0.5 mbar | Range depends on product temperature and equipment. |
| Typical product temperature | -40 °C to -10 °C | Measured during primary drying; formulation sets limits. |
| Water content after drying | 0.5-3% w/w | Target varies by material and stability needs. |
The process usually has three stages: freezing, primary drying, and secondary drying. Freezing sets the ice crystal structure and can determine pore size in the final cake. Primary drying removes free ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, although some water may remain as part of the solid. Cycle parameters depend on formulation, fill volume, vial type, and equipment performance.
The physical chemistry of freezing influences whether a formulation forms an amorphous glass or a crystalline solid. Amorphous systems can collapse if product temperature rises above the glass transition temperature of the freeze concentrate. Crystalline systems may show eutectic melting, where ice and solute melt together at a fixed temperature. Formulators add bulking agents, lyoprotectants, and buffers to preserve structure and biological activity. The optimum cycle keeps product temperature below critical thresholds during primary drying while allowing efficient sublimation.
Lyophilized solids are often hygroscopic, so handling occurs in controlled low-humidity areas or glove boxes when the material is exposed. Vials remain sealed with elastomeric stoppers and aluminum crimps until use, because airborne moisture can raise residual water and shorten shelf life. The porous cake is fragile and may crack, shrink, or powder during transport. Personnel typically avoid repeated warming and cooling of sealed units, which can draw moisture through closures. These practices aim to preserve the low water content achieved during drying.
Storage conditions depend on the formulation and the intended shelf life. Many pharmaceutical and biological freeze-dried products are kept at 2–8 °C, while some stable foods and reagents tolerate room temperature. Others require −20 °C or colder to slow chemical degradation or aggregation. Protection from light and oxygen is common because oxidation can continue in the dry state. Stability studies usually monitor potency, appearance, moisture, and reconstitution time over months or years. Predictions from accelerated studies are useful but may not fully capture real-time changes.
By using life cycle assessment tools he demonstrated the shortcomings of bioplastics and similar biomass based technologies intended as a substitute for the petrochemical processes used today. His main findings showed that changing from petrochemical to biomass-based processes often worsens their environmental impact and increases the emissions of carbon dioxide when compared to conventional processes based on fossil fuel stocks. With the recent mandate to increase biofuel content in the United States this area of research has become increasingly important, but to date has failed to guide public policy in the United States. Arguably, Gerngross' most important biotechnological contribution consisted of humanizing the glycosylation machinery in yeast to produce human therapeutic proteins, including antibodies, with fully human carbohydrate structures. Much of this work was conducted at Glycofi, Inc., a Lebanon, New Hampshire biotechnology startup company that was acquired in 2006 by Merck in a record-setting $400 million transaction. His work has been frequently cited in the popular press including The Times (London), CNN, Scientific American, BBC, The Guardian, The Economist, New Scientist, Nature Biotechnology and the Los Angeles Times. He has most recently been covered by the Boston Globe, CNBC, First Rounders, Evaluate Pharma, STAT and numerous others.
== Research == Due to its high biocompatibility, bioactivity, osteoconductive and/or osteoinductive capacity, nontoxicity, nonimmunogenic properties, and noninflammatory behavior, hydroxyapatite is available and used as a bone filler and as coatings on prostheses. Designing bone scaffolds with a higher capability of promoting bone regeneration is a topical research subject. Composite 3D scaffolds for bone tissue engineering based on nano-hydroxyapatite and poly-ε-caprolactone were designed. The 3D composite scaffolds showed good cytocompatibility and osteogenic potential, which is specifically recommended in applications when faster mineralization is needed, such as osteoporosis treatment.
=== 2002 === 20 July How to Live Forever, an Equinox Special, and update in October 1999's Curing the Incurable; the Center for Strategic and International Studies (CSIS), and possible huge demographic realignments facing Europe, with influx of citizens from less-wealthy continents, as well as a likely pensions crisis; Osiris Therapeutics; apoptosis and Ian Judson, and trials of imatinib for gastrointestinal stromal tumors (GIST); the Geron Corporation and the Hayflick limit; Human Genome Sciences of Rockville, Maryland, and regenerative medicine; Vandana Shiva of India; Sir Ian Wilmut of the Roslin Institute in Edinburgh. Produced by David Paterson, directed by David Malone, made by Boa 2001
This process, referred to as peptide stapling, uses non-natural amino acids to facilitate macrocyclization by ring-closing olefin metathesis. In this case, a stapled BH3 helix was identified which specifically activates the mitochondrial apoptotic pathway by antagonizing the sequestration of BH3-only proteins by anti-apoptotic proteins (e.g. Bcl-2, see also intrinsic and extrinsic inducers of the apoptosis). This molecule suppressed growth of human leukemia in a mouse xenograft model. Also in 2004, Harran and co-workers reported a dimeric small molecule that mimics the proapoptotic protein Smac (see mitochondrial regulation in apoptosis). This molecule mimics the N-terminal linear motif Ala-Val-Pro-Ile. Uniquely, the dimeric structure of this peptidomimetic led to a marked increase in activity over an analogous monomer. This binding cooperativity results from the molecule's ability to also mimic the homodimeric structure of Smac, which is functionally important for reactivating caspases. Smac mimetics of this type can sensitize an array of non-small-cell lung cancer cells to conventional chemotherapeutics (e.g. Gemcitabine, Vinorelbine) both in vitro and in mouse xenograft models. Heterocycles are often used to mimic the amide bond of peptides. Thiazoles, for example, are found in naturally occurring peptides and used by researchers to mimic the amide bond of peptides.
=== Pharmacokinetics === Salvinorin A is effectively deactivated by the gastrointestinal system, so alternative routes of administration must be used for better absorption. It is absorbed by oral mucosa. It has a half-life of around 8 minutes in non-human primates.
Sources: en.wikipedia.org
== Connection with schizophrenia == Exorphins can cause various symptoms of schizophrenia if mutation occurs at a few selected loci. Genetic mutation at one of these loci can lead to increased absorption of exorphins via receptor mediated endocytosis. Another possibility from these particular loci is that catabolization of exorphins can be disrupted thus allowing the exorphin to persist in the body. This would lead to exorphins entering the brain capillary, bypassing the blood brain barrier, and inflicting negative repercussion on the brain. This does not mean that exorphin will necessarily cause schizophrenia, as susceptibility to the disease is dependent on an individual's genetic makeup. However, by increasing the probability that exorphins enter the brain, it will also increase the chance of an individual displaying schizophrenic symptoms.
After transplantation, liver biopsy is the best method to monitor the evolution of post-transplant fibrosis, with significant fibrosis or portal hypertension one year after transplantation predicting rapid progression and graft loss and indicating the need for urgent intervention.
== In fiction == The science fiction novella Sucker Bait by Isaac Asimov centres on a planet on which the first settlers all died of berylliosis, due to high concentration of beryllium in the planet's crust.
CSA is organized into 6 individual syndromes: Cheyne-Stokes respiration, Complex sleep apnea, Primary CSA, High altitude periodic breathing, CSA from medication, CSA from comorbidity. Like in OSA, nocturnal polysomnography is the mainstay of diagnosis for CSA. The degree of respiratory effort, measured by esophageal pressure or displacement of the thoracic or abdominal cavity, is an important distinguishing factor between OSA and CSA.
Sources: en.wikipedia.org
Soon after Crick's death, there have been allegations about him having used LSD when he came to the idea of the helix structure of the DNA. While he almost certainly did use LSD, it is unlikely that he did so as early as 1953. In the late 1960s he was given LSD by Henry Todd who met Crick through his girlfriend who had modelled for Crick's wife.
Valve is an American video game developer and publisher founded in 1996 by Gabe Newell and Mike Harrington. The company is based in Bellevue, Washington. Valve's first game was Half-Life, a first-person shooter released in 1998. It sold over nine million retail copies. Alongside Half-Life's launch, Valve released development tools to enable the player community to create content and mods. The company then proceeded to hire the creators of popular mods such as Counter-Strike. Valve continued their trend of developing predominantly first-person video games in the 2000s with a number of critically successful releases. In 2004, they released the highly anticipated sequel Half-Life 2 through their own digital distribution service Steam. The game sold over 10 million copies and was met with acclaim. Valve released two subsequent episodes for Half-Life 2 and later packaged those games together with the puzzle game Portal and the multiplayer shooter Team Fortress 2 in a collection known as The Orange Box. By the end of 2008, combined retail sales of the Half-Life series, Counter-Strike series and The Orange Box had surpassed 32 million units. Newell also projected that digital sales of Valve's games would eventually exceed retail sales as Steam continued to grow. In the late 2000s, Valve released two zombie-themed first-person shooters focusing on cooperative gameplay with the Left 4 Dead series. The company continued to release multiplayer games with the launches of Counter-Strike: Global Offensive and Dota 2, both of which have large esports communities fostered by Valve.
When the digested food particles are reduced enough in size and composition, they can be absorbed by the intestinal wall and carried to the bloodstream. The first receptacle for this chyme is the duodenal bulb. From here it passes into the first of the three sections of the small intestine, the duodenum (the next section is the jejunum and the third is the ileum). The duodenum is the first and shortest section of the small intestine. It is a hollow, jointed C-shaped tube connecting the stomach to the jejunum. It starts at the duodenal bulb and ends at the suspensory muscle of duodenum. The attachment of the suspensory muscle to the diaphragm is thought to help the passage of food by making a wider angle at its attachment. Most food digestion takes place in the small intestine. Segmentation contractions act to mix and move the chyme more slowly in the small intestine allowing more time for absorption (and these continue in the large intestine). In the duodenum, pancreatic lipase is secreted together with a co-enzyme, colipase to further digest the fat content of the chyme. From this breakdown, smaller particles of emulsified fats called chylomicrons are produced. There are also digestive cells called enterocytes lining the intestines (the majority being in the small intestine). They are unusual cells in that they have villi on their surface which in turn have innumerable microvilli on their surface.
Sources: en.wikipedia.org
Conventional drying uses heat to evaporate liquid water, often at temperatures that can degrade sensitive materials. Lyophilization freezes the material first and then removes water by sublimation under vacuum. This avoids prolonged exposure to liquid water and high heat.
Lowering pressure reduces the boiling point of water and allows ice to sublimate at temperatures below freezing. Vacuum also limits convective heat transfer, so heat is usually supplied by shelves or radiation. The pressure must stay below the vapor pressure of ice at the product temperature.
The cycle typically includes freezing, primary drying, and secondary drying. Freezing solidifies water and sets the pore structure; primary drying removes bulk ice; secondary drying removes bound water. Some cycles add annealing or pre-freezing steps.
Most lyophilized products are stored in sealed containers at controlled temperature and humidity. Some require refrigeration, while others are stable at room temperature. Protection from light and moisture is often necessary.